Using a smoothing tool, work from the center of the strip to the edges and remove any air bubbles. When the top portion is smooth and the positioning is perfect, unroll the bottom half and continue smoothing, allowing the paper to overlap the baseboard. Double check that all air bubbles have been removed and that the strip is securely fastened to the wall. Move your ladder over to hang the second piece of wallpaper. Follow Step 3 for each piece of wallpaper you hang. If there's a pattern to line up, hold the piece up by the top end and line up both pieces of paper.
These wallpaper removal tips (secrets!) and tools turn the worst DIY gig into a no-brainer. The first recipe is fabric softener wallpaper stripper. Combine one capful of fabric softener with four cups water. Fabric softener wallpaper stripper is the first recipe. Combine one capful of fabric softener and four cups of water in a mixing bowl.
Now you should have the top 36 inches (91.4 cm) of wallpaper applied to the wall with the rest of the paper still folded up. You will have to move the adjacent strip up or down in order to match the pattern to the previous strip. When cutting a drop pattern, it's easiest to cut and hang one piece at a time. After you have one strip on the wall, you can easily see where the pattern on the next piece should begin in order to match. You may lose a foot or two of paper as you adjust for matching, but any large scraps you have left over are good to keep for future repairs or touch-ups. All of our traditional rolls are 27 inches wide.
Modern wallpaper is available in paste-the-back, paste-the-wall and peel and stick formats. The heavier and more flexible the paper you choose, the easier it is to apply without creases or risking tears. And, the benefit of peel and stick wallpaper is that removing it is a total breeze.
Remove the wallpaper and brush wallpaper adhesive on the section you best wallpapers just marked off but just the top part. Hanging wallpaper on one wall is way easier than wallpapering a full room. Especially if the wall doesn’t have any windows or doors, it’s super easy and can be done in a couple of hours. Painter’s tape can be pricey, and if you need to use a lot on your walls to get the paper to fully stick, you may not save any money in the long run.
Measure the height of the wall, then cut a length of wallpaper with an extra two inches at the top and bottom of the strip. The best practice is to cut and hang one strip at a time to ensure the pattern is a seamless match and to avoid wasted paper. If you plan on painting the trim or ceiling, complete this job before hanging wallpaper to avoid drips on the finished surface.
CÔNG TY TNHH THÁP GIẢI NHIỆT CÔNG NGHIỆP GOLDSUN VIỆT NAM